Propellerhead Reason - 4.0 Provozní příručka stáhnout pdf (Strana 318)

REBIRTH INPUT MACHINE

316

Introduction

The ReBirth Input Machine is a device dedicated to receiving audio from the Propel-

lerhead program “ReBirth RB-338” (version 2.01 and later). This is achieved by using

ReWire technology (see page 124), where Reason will act as master and ReBirth as

a slave device. If you don’t have ReBirth installed, you cannot use this device. If you

are a ReBirth user, you can use the ReBirth Input Machine for the following:

D Receive up to eighteen channels of streaming ReBirth channels in Rea-

son.

You can create more ReBirth Input Machines, but only one can be active at a time.

D Sample accurate synchronization between the audio in the two pro-

grams.

D The two programs can share the same audio card and take advantage of

multiple outputs on that card.

Preparations

For the ReBirth Input Machine to correctly operate together with ReBirth, the launch

and quit order is very important. Proceed as follows:

Launching

1. Launch Reason.

2. Create a ReBirth Input Machine.

You may want create a Mixer prior to this step, otherwise the L/R Mix channels will

be routed directly to the Audio Hardware Interface. If you have a Mixer, the L/R Mix

output from the ReBirth Input Machine will be automatically connected to the

mixer’s first available audio inputs.

3. Launch ReBirth.

4. When ReBirth is launched, select Reason as the application in focus.

If both the “Reason is Rewire Master” and the “Active” indicator on the ReBirth In-

put Machine are lit, this indicates that the launch procedure was correct and that

Reason and ReBirth are now locked and in sync.

D If only the “Active” indicator is lit, either the launch order was wrong, or

ReBirth is not installed properly.

5. Activate playback on Reason’s transport panel.

ReBirth and Reason are locked in perfect sync, and will follow any transport com-

mands in either of the programs.

! Note that there is no master/slave relationship for the transport controls

when using ReWire, as either device will control the other device’s trans-

port. The audio, however, is streamed from ReBirth to Reason, so in this

aspect Reason is the master device.

Quitting

1. First quit ReBirth.

2. Then quit Reason.

1 2 ... 313 314 315 316 317 318 319 320 321 322 323 ... 401 402

Žádné komentáře

Propellerhead Reason - 4.0 Provozní příručka Strana 318